Sanyo Denki Closed loop stepping system 4-axis integrated driver

Since a single driver can drive a 4-axis stepping motor, it can be installed in less than half the space of four drivers conventional by the manufacturer.
Since there is only one power supply and input / output signal line, less wiring is required.
In addition to the conventional closed-loop control that does not cause step-out, which is a weak point of the stepping motor, it is equipped with a control mode that does not delay the position command.
Since there is no delay with respect to the position command, the tact time of the device is shortened.
The resolution of the position command can be set between 200P / R and 51200P / R.
It can be driven according to the resolution required for the device.
Easy to analyze settings and operating conditions.
With the setup software that can be downloaded from the manufacturer's HP, you can easily set control parameters, monitor the operating status, and perform test runs on your computer.
Semiconductor-related equipment, food-related equipment, general industrial machinery, etc.