SK11 screw removal impact driver

Also turn screws whose grooves have been crushed by licking.
Converts the impact of a hammer into rotational force, making it possible to loosen tightly tightened screws.
Comes with a special bit to remove screws whose grooves have been crushed by licking. Hit with a hammer to create a new groove and remove the screw.
The flattened Phillips screw removal bit is compatible with M3 to M6 countersunk screws, pan head screws, truss screws, etc.
Removing screws with crushed thread grooves.
Tamed Phillips screw removal bits cannot be used on very hard screws such as course red, self-tapping screws, or drill screws. If you drive into them with a hammer, the tip of the bit may be damaged.
Do not use in locations where there is a risk of damage or deformation of the screwed material due to hammer blows.
Please do not use it on anything that carries electricity.
Please use screws that match the size.
Please wear safety glasses and protective equipment when working.
Please do not use it for any purpose other than its original purpose.